Morpho Driver
Update Date :
2024-08-13
Model :
MSO1300E3 L0
Device Name :
Android
Download Driver :
USER MANUAL Morpho RD Service (Windows)
Classification: OT-MORPHO Restricted Version 1.1 Page 3 of 10
1. Introduction
1.1. Purpose
Purpose of the document is to assist end-user in installation of Morpho RD Service and
using it with MorphoSmartTM Biometric Finger Print Device.
2. S/W and H/W Requirement
2.1. Prerequisites for S/W
MORPHO Biometric Finger Print Device is successfully integrated with customer
business application.
Windows 7, 8, 8.1, 10 (32 bit and 64 bit)
2.2. Prerequisites for H/W
MSO1300 E, MSO1300 E2, MSO1300 E3 Fingerprint Sensor Device
2.3. Calling Application Details
AUA/KUA client application or any other customer business application to which
MORPHO Biometric Finger Print Device is integrated.
3. Installation steps
1. Run 'MorphoRdServiceL0SoftSetup.exe' with administrator rights to install the RD
Service and follow the instruction in setup wizard to complete the installation.
Installation steps
1. Run 'MorphoRdServiceL0SoftSetup.exe' with administrator rights to install the RD
Service and follow the instruction in setup wizard to complete the installation.
2. On successful installation, please make sure following path is created on C Drive with 35 files.
3. To check the RD Service is running , please run following command on Run Window in Administrative Mode
In case of successful installation, following RD Service status would be shown.
4. Plug-in the MORPHO Biometric Finger Print Device. If MORPHO USB driver is installed successfully, the device would be detected (light will be blinked for fraction of second).
5. After running the business application which is integrated with MORPHO RD Service, it will prompt to enter One-time-token may appear if the connected device is not whitelisted at SCPL RD management server. Enter the provided token for RD Service to launch successfully.
6. For device whitelisting procedure, please refer to FAQs in next section of document.
Share :
Add New Comment